The guts of the center console are clearly visible in this picture. This construction made for the most part out of CNC milled 12mm MDF was the support structure of the installation. Almost all of the electronic guts of KUDA were housed in this unit (pumps, PCBs, solenoid valves, power supplies). Using a series of 3 x 63mm pipe clamps the PE80 rings that supported the structure were held in place. Initially the console was designed to allow easy acces from the sides to connect electronics and pumps, however, most of the work was done by crawling underneath in the end ! The slot designed for housing the water reservoirs proved to be a much easier way to reach all the nessecary components.